Defiant DF-5928-WH Instruction Manual Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
10
Care and Cleaning
Ƒ To prolong the original appearance, clean the light xture with clear water and a soft, damp cloth only.
Ƒ Do not use paints, solvents, or other chemicals on this light xture. They could cause a premature
deterioration of the nish. This is not a defect in the nish and will not be covered by the warranty.
Ƒ Do not spray the light xture with a hose or power washer.
Troubleshooting
Problem Possible Cause Solution
The light will not come on. Ƒ The light switch is turned off. Ƒ Turn the light switch on.
Ƒ The fuse is blown or the circuit breaker
is turned off.
Ƒ Replace the fuse or turn the
circuit breaker on.
Ƒ Daylight turn-off (photocell) is in effect. Ƒ Recheck after dark.
Ƒ The circuit wiring is incorrect (if this is
a new installation).
Ƒ Verify the wiring is correct.
Ƒ The motion sensor is aimed in the
wrong direction.
Ƒ Re-aim the motion sensor
to cover the desired area.
Ƒ The outside air temperature is close to
the same as a person’s body heat.
Ƒ Increase the “SENS”
setting.
The light comes on during the
day.
Ƒ The motion sensor may be installed in a
relatively dark location.
Ƒ The light xture is operating
normally under these
circumstances.
Ƒ The “ON-TIME” switch is in the “TEST”
position.
Ƒ Set the “ON-TIME” switch
to the 1, 5, or 20 minute
setting.
The light comes on for no
apparent reason.
Ƒ The motion sensor may be sensing
small animals or automobile trafc.
Ƒ Decrease the “SENS”
setting or reposition the
motion sensor.
Ƒ The “SENS” switch is set too high. Ƒ Decrease the “SENS”
setting.
Ƒ The “DUALBRITE” switch is in the 3
hour, 6 hour, or dusk-to-dawn setting.
Ƒ The light xture is operating
normally under these
circumstances.
Ƒ The outside temperature is much
warmer or cooler than a person’s body
heat (summer or winter).
Ƒ Decrease the “SENS”
setting.
Ƒ The light xture is wired through a
dimmer or timer.
Ƒ Do not use a dimmer or
timer to control the light
xture. Replace the dimmer
or timer with a standard on/
off wall switch.
The lights turn off too late in the
Dusk-to-Dawn setting.
Ƒ The light xture may be installed in a
relatively dark location.
Ƒ Relocate the light xture
or use the 3 hour or 6 hour
setting.
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Comments to this Manuals

No comments